Reply to thread

Mark,I think you've gotten what NO ONE else has ever acheived with regards to the ESB flame thrower assembly!!!! I've seen alot of ESB Fetts in 2 years,and NONE have gotten this important detail done well enough to my standards.While I've been doing yardwork by daylight,you've done the hard work for us all  :)  The last thing is the rear bracket.In the pics I have it looks like it might be 1 1/2" angle aluminum,but then the top section has what appears to be a 45degree angle on it.I know that might sound like greek,.....maybe I'll have to email you what I mean by outlining in on a pic in red.


Steve


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top