Reply to thread

Her are some pics for the Rods I'm designing. I included the bracket, calc pad and glove for scale. The thinnest section of rod is 1/4" the thickest is 3/4" most are around 5/16" to 1/2". The tip of the longest rod to the top of the bracket is 5.5" long. I am working on the three cylinders behind the bracket and am figuring 1.5" for those and another 1" for the endcap. In total the overall length will be 8.5625" or 8 9/16". I'll update the pics when I get the back cylinders drawn up.There appears to be some conflicting things in the various pics so I tried to homogenize what I thought the discrepncies were into this design (they could be just shadows and what not).Suggestions how about porportions etc.? -Mark


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top