Ghost_Fett
Hunter
Hey guys is there a name or particular type of hose that’s always used for the ESB gauntlet?
ESB gauntlet hose?
- Thread starter Ghost_Fett
- Start date
TheZeroEffect
Active Hunter
Braided clear hose, 10mm, it’s a high pressure hose, you can find it at most hardware stores.
I was a bit cheeky and used a 8mm hose because it flexis more
I was a bit cheeky and used a 8mm hose because it flexis more
Ghost_Fett
Hunter
Awesome thanks
how did you weather yours?
TheZeroEffect
Active Hunter
There is a bit of a hint in the photos
I used enamel paints as they stick better to the hose. Paint goes on, using either a paint brush or toothbrush. I let it sit for a few minutes and then useing paper towel dab it off, leaving behind a thin film of paint. I then repeat this process with various earth colours over and over slowly building up the grime look till I’m happy.
The couplings use to be shinny aluminium when I started.
Hope that helps a bit.
I used enamel paints as they stick better to the hose. Paint goes on, using either a paint brush or toothbrush. I let it sit for a few minutes and then useing paper towel dab it off, leaving behind a thin film of paint. I then repeat this process with various earth colours over and over slowly building up the grime look till I’m happy.
The couplings use to be shinny aluminium when I started.
Hope that helps a bit.
