ESB Gauntlet / Flamer


Active Hunter
Anyone got advice for makin the Flamer for an ESB Gauntlet.
the one that came with my gauntlets is Resin and ultimately not great in the way it's put together - it's kinda fragile - and I'm thinkin of makin it from scratch.
Any hints on where to start off?
I used most of the resin one, but replaced the rods by drilling out the individual pieces and putting wooden rods inplace...

DSCN1361 small.jpg
It looks like the ZIP file has disappeared, PM me with your e-mail address and I send them to you. I'll try to get it back on line in the near future, I'm currently out of space, again.

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.