Reply to thread

exactly that’s what i thought.


here is how the pieces align out of the box


[ATTACH=full]193726[/ATTACH]

[ATTACH=full]193727[/ATTACH]


the calculator piece doesn’t fit either, i will need to dremel a little off the gauntlets to get it to fit.


[ATTACH=full]193728[/ATTACH]


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top