Hello everyone!
I’m fairly new to the forum, but have found it to be a wealth of knowledge!
I’m building an ESB Boba Fett helmet. I’ve decided to go down the scratch building method, as I like a challenge. Only after I started and spent some time on here, I realised how many little details and features make the relativity simple looking helmet what it is.
Here is my progress so far:
[ATTACH=full]175617[/ATTACH]
[ATTACH=full]175618[/ATTACH]
Initial cardboard model to get a rough size and shape.
[ATTACH=full]175619[/ATTACH]
[ATTACH=full]175620[/ATTACH]
A coat of resin, a few scrapes of body filler and a standard "look what I'm making" photo.
[ATTACH=full]175621[/ATTACH]
[ATTACH=full]175622[/ATTACH]
Refining a few details with some 1mm foamex.
[ATTACH=full]175623[/ATTACH]
I drew up the ear details and 3D printed them.
[ATTACH=full]175624[/ATTACH]
[ATTACH=full]175625[/ATTACH]
[ATTACH=full]175626[/ATTACH]
[ATTACH=full]175627[/ATTACH]
A few coats of primer and I started on the dent. I cut the dent shape out with a drill and dremel, then build it back in with slices of 1mm foamex. The forehead arrows were engraved in with a dremel.
[ATTACH=full]175628[/ATTACH]
The rangefinder top was drawn up and 3D printed like the ears. The stalk was cut on a CNC router at my work. The top of the RF is in 3 parts to allow me to cast the 'perspex block' in clear resin.
[ATTACH=full]175629[/ATTACH]
Though not installed yet, I turned the borden connector on a lathe ready for moulding and casting
[ATTACH=full]175630[/ATTACH]
[ATTACH=full]175631[/ATTACH]
[ATTACH=full]175632[/ATTACH]
[ATTACH=full]175633[/ATTACH]
[ATTACH=full]175634[/ATTACH]
This is the helmet as it stands at the moment (sorry for low res phone pics). I still need to add the little cheek rectangle and sharpen up a few parts, but thought it would be good to get some constructive criticism before going any further.
Please be gentle!