Reply to thread

Message

The only definitive ESB colors i have found are for the bucket, so i decided to just wing it on the armor. I used a chrome base, with a testors zinc oxide over that, used liquid mask on both colors, then i sprayed with 2 coats of rustoleum spruce green followed by 2 coats of testors medium green. Then i misted with some acrylic black and peeled the latex off.

And here is what i have so far, the chest pieces arent done yet. Your feedback on the colors are most welcome and helpful

[ATTACH=full]78998[/ATTACH]

[QUOTE="patiam69, post: 37528, member: 383"] The only definitive ESB colors i have found are for the bucket, so i decided to just wing it on the armor. I used a chrome base, with a testors zinc oxide over that, used liquid mask on both colors, then i sprayed with 2 coats of rustoleum spruce green followed by 2 coats of testors medium green. Then i misted with some acrylic black and peeled the latex off. And here is what i have so far, the chest pieces arent done yet. Your feedback on the colors are most welcome and helpful [ATTACH=full]78998[/ATTACH] [/QUOTE]

This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification