Reply to thread

Message

Thanks, I thought it might have been plastic. How does the knurled rings compare? It's hard for me to tell but it looks.......... fatter possibly or sits higher from the branded eyepiece? It's hard for me to tell but obviously I don't have the two scopes to compare.

I didn't notice the positioning of the windage block at all.

With the unbranded piece do you mena that it sits entirely flush to the tube where the two meet? I'm a bit confused... which isn't difficult. Really.

[QUOTE="intwenothor, post: 345549, member: 4118"] Thanks, I thought it might have been plastic. How does the knurled rings compare? It's hard for me to tell but it looks.......... fatter possibly or sits higher from the branded eyepiece? It's hard for me to tell but obviously I don't have the two scopes to compare. I didn't notice the positioning of the windage block at all. With the unbranded piece do you mena that it sits entirely flush to the tube where the two meet? I'm a bit confused... which isn't difficult. Really. [/QUOTE]

This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification