Reply to thread

Message

With TK-409's measurments of the base webley of the ROTJ gun, I scaled down wizardoflight's templates and edited them to be able to make easy plexi-glas forms.

there 1:1 the chamer just needs to be bend an bondo'd with a pvc pipe in it, an ur home free...

[ATTACH=full]1301[/ATTACH]

[ATTACH=full]1302[/ATTACH]

[QUOTE="RBF, post: 49647, member: 604"] With TK-409's measurments of the base webley of the ROTJ gun, I scaled down wizardoflight's templates and edited them to be able to make easy plexi-glas forms. there 1:1 the chamer just needs to be bend an bondo'd with a pvc pipe in it, an ur home free... [ATTACH=full]1301[/ATTACH] [ATTACH=full]1302[/ATTACH] [/QUOTE]

This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification