Reply to thread

Ok so last night I worked on the key slots. I had a hairline fracture going down the one side of the keyslots that I filled in with Bondo yesterday. I sanded it all down and began cutting the slots out using a drill to make several piolet holes and then finishing them off with Hobby Files. Well, I no sooner got all of them carved out and was working on the top one when the material between the top slot and 2nd slot gave way on the one side. It was still in pretty firm so I ddn't have do much to keep it in place. I went to work quickly though and whipped up a quick batch of Bondo and reinforced the interior behind the key slots. I also put a little over the thin crack too. I checked on it this morning and to my pleasure, it feels really solid so I think that did the trick! I was swetting bullets there for a second though!


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top