Heres my update for this weekend!
So looking at the helmet i noticed that the strip that goes all the way around separating the dome from the bottom half of the helmet, was a little tilted downward towards the back. So i decided to tackle that next...
I marked off with tape where it should be..
[ATTACH=full]105584[/ATTACH]
[ATTACH=full]105585[/ATTACH]
[ATTACH=full]105586[/ATTACH]
I then used the cutting wheelon my trusty dremel and trimmed it away.Since it was stillthe posterboard,it was easy to remove. the white strip is where the posterboard i removed was.
[ATTACH=full]105587[/ATTACH]
[ATTACH=full]105588[/ATTACH]
i then added on bondo to form the strip, carved ita bit with a box cutter blade before it was fully cured,and sanded it to shape. I also angled upward the bottom rear edge of the cheekbone area,as it was going straight outandit should have the angle like the bottom of the cheek. i alsoadded the triangle detail to the for head. i stillthink i wanna take down the front of the dome a little bit more though.
[ATTACH=full]105589[/ATTACH]
next to my BM again
[ATTACH=full]105590[/ATTACH]
[ATTACH=full]105591[/ATTACH]
and heres a couple of just mine alone
[ATTACH=full]105592[/ATTACH]
[ATTACH=full]105593[/ATTACH]
[ATTACH=full]105594[/ATTACH]
Im hoping ill have the main helmet done by the end of next weekend. Everything will still need to be cleaned up and straightened out perfect before i even think about taking a mold from this. It is still a tad rough in spots. But once i fix all that, i will then make the keyslot area and the ears.
[ATTACH=full]104930[/ATTACH]
[ATTACH=full]104931[/ATTACH]
[ATTACH=full]104932[/ATTACH]
[ATTACH=full]104933[/ATTACH]
