Reply to thread

Prices are definitely going down.  My Metal Plus was the cheapest pre-assembled 10x10x10 printer I could find.  (I wanted to do helmets.)  Unfortunately, it's not stable enough to do really large prints like helmets.  They always fail.  But, it's  nice to have the extra couple of inches for guns and larger props. 


Mark


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top