Reply to thread

Well looks like anycubic shipped my order.. but instead of getting my printer and resin. All they sent was resin.... :(



Anyways, I buffed the armor more. There is some spots all over the entire armor that there isnt any powder pigment? Just straight up gray spots? Not sure my fault if I buffed too much or there isnt powder in some areas. Also the knee armor sides had no powder. So I had to rub and buff those.


[ATTACH=full]194610[/ATTACH][ATTACH=full]194611[/ATTACH][ATTACH=full]194612[/ATTACH][ATTACH=full]194613[/ATTACH][ATTACH=full]194614[/ATTACH][ATTACH=full]194615[/ATTACH]


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top