Reply to thread

Well I installed the toggle switches in the gauntlet. While they look ok, I had to break them so they're not functional. I just couldn't fit them in the weird angle they're in. I also had to remove a bunch of the gelcoat and the edges in the inside where thinning. They still look very cool.


[ATTACH=full]194005[/ATTACH]


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top