Reply to thread

Message

I buffed a thin layer on most of the armor today. Yesterday I fiberglassed some areas for extra strength. Backplate, shins, knees, gauntlets. The lower talon part of the codpiece also strengthened.

Side note, I got the CNC machinist apprenticeship today. Pretty happy about that! It's my next step in life. I can hope in the near future learn how to operate the lathe and CNC router I have at my shop. Bought and never learned. But now is my chance.

[ATTACH=full]193576[/ATTACH]
[ATTACH=full]193578[/ATTACH][ATTACH=full]193579[/ATTACH]

[QUOTE="droidbait, post: 498576, member: 5642"] I buffed a thin layer on most of the armor today. Yesterday I fiberglassed some areas for extra strength. Backplate, shins, knees, gauntlets. The lower talon part of the codpiece also strengthened. Side note, I got the CNC machinist apprenticeship today. Pretty happy about that! It's my next step in life. I can hope in the near future learn how to operate the lathe and CNC router I have at my shop. Bought and never learned. But now is my chance. [ATTACH type="full"]193576[/ATTACH] [ATTACH type="full"]193578[/ATTACH][ATTACH type="full"]193579[/ATTACH] [/QUOTE]

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification