Reply to thread

We are now down to the last two darts. They should be done by this week. I also ordered a large resin printer. That should come in the next few weeks. Sizing will be for Cruzer gauntlets but they will work with just about any.

[ATTACH=full]192948[/ATTACH]


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top