Reply to thread

Go with a Dremel with a cord.  They rule.


BUT, like someone earlier said, wear eye protection!  A few days ago I was cutting Styrene without any and a molten hot piece flew into the corner of the eye and it burned like hell.  Not smart..


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top