Reply to thread

I am hoping most of you are familiar with the DP 95 and can help out. When I removed the factory visor, I did not sand down the inside of the bucket where the mandibles are and I am wondering if I should have done this. Would sanding the excess off make a visor fit better? Am I making any sense?


edit:  here are some pics


[ATTACH=full]94601[/ATTACH]


[ATTACH=full]94602[/ATTACH]


[ATTACH=full]94603[/ATTACH]


[ATTACH=full]94604[/ATTACH]


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top