Reply to thread

DL-44 SolidWorks and Pepakura models (And now - LL-30 too =)


Hi all,

I just want to inform you - I just finished DL-44 blaster model in SolidWorks and prepared the model for papercraft build in Pepakura designer =)

(Press on picture to enlarge)

 

 

[ATTACH=full]107849[/ATTACH]

 

[ATTACH=full]107850[/ATTACH]

 

If you want to download eDrawings ineractive viewer with this model embedded, go there. ZIP-password: weequay

 

Model for Pepakura designer and viewer is there

ZIP password is the same as in previous archive.

Model still needed to be unfolded and looks like that:

 

[ATTACH=full]107851[/ATTACH]

 

Best regards.


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top