Desperatly need an ESB Flame Thrower

Thread starter purple sith
Start date Jun 8, 2007

purple sith

New Hunter

Jun 8, 2007

Hey Gang,

I'm really in need of a decent ESB flame thrower, Ideally i'd love one of them machined aluminium ones, but in the meantime a good resin one would do. The one i have at the momen is giving me just too much trouble, seems the resin that the main body is made from hasn't been mixed too well, so keeps on 'sweating' out oily stuff, so when i paint it, the damn paint wont dry, grrr!

Any help greatly appreciated!!!

This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.