Using solder.... heated up then let drop on to a metal surface gives a splash effect.....this can easily be pressed into the dent on your helmet....the pic don.t do it much justice.....but it looks very aint fixed in permantly yet........just an idea...........

HAM dent.JPG
ya i tryed that awile back on my armor just for fun & it came out pretty kewl. its alittle harder to get the splash to cover larger dentes though
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.