So it seems that it has been a long time since I have posted about my build. I haven’t given up, it’s just life has found a way to slow things down. This post is very picture heavy.
So a while ago I was able to lay out my armor in its semi cut out form.
[ATTACH=full]176785[/ATTACH]
Here is the helmet and ear caps as they were when this picture was taken. I have a few detail pieces to work on and then I can lay down the body filler. Eventually before I install the earcaps and paint it, I will be casting it in silicon to be the MK2 version of the DWC helmet I sell.
[ATTACH=full]176786[/ATTACH]
Here are the boots with the armor just set on them.
[ATTACH=full]176787[/ATTACH]
As you can see from the layout of my armor, I am building the backplate from scratch and in two pieces.
[ATTACH=full]176788[/ATTACH]
Here’s the armor laid out.
[ATTACH=full]176789[/ATTACH]
Close up of the boots with the armor.
Westar Carbine
[ATTACH=full]176790[/ATTACH]
Here are the templates all laid out.
[ATTACH=full]176791[/ATTACH]
The wood parts all cut out and the Sintra parts traced out.
[ATTACH=full]176792[/ATTACH]
All pieces cut out
[ATTACH=full]176793[/ATTACH]
Laid out
[ATTACH=full]176794[/ATTACH]
Here are all the weapons for my new kit. The Westar 35 are the same casting as I sell.
[ATTACH=full]176795[/ATTACH]
Here is the carbine ready for paint.
[ATTACH=full]176796[/ATTACH]
This is the first time I’ve put in my soft good for my deathwatch Mando. I need to add a small snap at the neck, take in the legs and raise the hem on the legs on the flight suit. The vest just needs the shoulders to be attached. I used an old turtle neck shirt for the neck seal and long sleeves.
Well that’s is the update I have at this moment. Hopefully I will have more updates sooner rather then later.
