Reply to thread

Straight out of the mold with only a little trimming of flashing along the edges. I always try to find a happy medium between being lightweight yet durable for maximum comfortability when wearing. I’m happy with the weight, and plan to make most of the attachment pieces foam filled hollow rotocast copies to further this idea. Now off to finish the attachment piece molds...


[ATTACH=full]159455[/ATTACH]


[ATTACH=full]159456[/ATTACH]


[ATTACH=full]159457[/ATTACH]


[ATTACH=full]159458[/ATTACH]


[ATTACH=full]159459[/ATTACH]


[ATTACH=full]159460[/ATTACH]


[ATTACH=full]159461[/ATTACH]


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top