Reply to thread

Very nice job without question! And the best thing about it is that it's a one of a kind, I assume anyway...I was starting to look into doing a Barrett sniper rifles muzzle brake, which it looks like you crafted a similar one as well. What did you make it from and could you possibly show some close up pics of the muzzle? Once I get it done I have to design a stock for it, which should be tricky as I'm drawing a blank as far as coming up with an original design...Anyway, great job-can't wait to see the next one!


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top