Reply to thread

Message

First, ya need to decide where the chest display should go. (I don't know if the FP armor comes with the indentations of where it should go ... my FP armor arrived with the slits already cut.) I would then suggest you draw out where the display should show through and then use an exacto knife to cut out the drawn area and then sand it down so it's smooth.

Anyway, just my opinion. I will say just make sure you take your time if you do it this way.

[QUOTE="Jimmy BufFETT, post: 93613, member: 1286"] First, ya need to decide where the chest display should go. (I don't know if the FP armor comes with the indentations of where it should go ... my FP armor arrived with the slits already cut.) I would then suggest you draw out where the display should show through and then use an exacto knife to cut out the drawn area and then sand it down so it's smooth. Anyway, just my opinion. I will say just make sure you take your time if you do it this way. [/QUOTE]

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification