Reply to thread

If its fiberglass id just use a Dremal and then use a fingernail flie to make the edges square. Or if you can make a cut through the armor, use a hack saw very slowly to cut it.

Im sure someone has better ideas.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top