Reply to thread

You can go about it two ways....you can spray the parts you want to weather silver, then when that's dry for a few days, cover it in flat black and when the black is dry, sand off till you see silver.

I have had good luck with that aluminum tape...laying down narrow strips and then painting over it and sanding.

Or you can take a brush or a rag and just smear on the silver until it looks good.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top