Reply to thread

I was approved a while ago but I wanted to tell people how I fixed my nagging gauntlet hose issue. Some people suggested that I utilize sticking the hoses in water to heat them up. I actually did something similar, but didn't use water. I took a heat gun to the hoses and heated the length of the hoses. I went over the entire hose area two times. The first time it got a good bunch of the curve out, the second my hoses wanted to be straight as an arrow. Worked great.


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top