Reply to thread

**UPDATE** CONVERTING BKBT's JANGO BUCKET TO BOBA *PICS*


Here's a few pics of my progress on converting BKBT's Jango bucket to a Boba. First I would like to thank BKBT for creating such a beautiful bucket. It was hard to make that first cut! :lol: So far I have trimmed some of the back off of the helmet to give it a more accurate Boba angle. I have drilled out the hole for the Borden Connector(thanks MaxPlague) as well as cut out the little rectangle on the opposing side. Oh, yeah, and I finally got up the nerve to make the dent. Yeah, I'm going for RotJ with the paint scheme(thanks Shortimer52), so I figured I ought to make the dent RotJ. Anyway enjoy the pics.


[ATTACH=full]687[/ATTACH]


[ATTACH=full]688[/ATTACH]


[ATTACH=full]689[/ATTACH]


[ATTACH=full]690[/ATTACH]


[ATTACH=full]691[/ATTACH]


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top