Reply to thread

Thanks for the pic nice and clear.

 The material I am using is the same as plastic guttering is made of over here in the UK dark grey but in sheet form about 2ft x 3ft bends in boiling water. I was going to use car filler on the edge between the tear drop and the main body of the cod, sanding it down to give it a more rounded shape so it looks like one piece (hope that made sense)


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top