Reply to thread

It is a 3d printed piece that is in the shape of a U. It has a 3-inch tongue on the inside of the pack that is held in place by 3 bolts. The outside part of the U is just the inch ledge you see in the picture to catch the edge of the hole in the back of the jetpack.


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top