Cobb Vanth/Acid Washed Boba Helmet Build

Thread starter Purged Databank
Start date May 25, 2022

Purged Databank

New Hunter

May 25, 2022

Nearly done with this build. Anyone have any tips for an accurate Cobb Vanth armor kit? May just make my own with my printers lol. This is a resin casted kit from MinuteFett's "Boba Fresh" kit. Just need to figure out how I am doing the killstripes then finish the topper and install the visor. Thoughts? Concerns? Questions?

This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.