Reply to thread

Post the pics, and I'll see what I can tell you. Oh, and dartbhoba, to answer your original question, if you can find some templates, than I would suggest using them to make each piece out of cardboard (because it's easy to work with), then making a mold off of those pieces, and using the mold to make actual plastic parts: that's what I'm going to try.


This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top