Reply to thread

Message

i ended up using a plastic bonder 2 part epoxy i found at menards. that stuff is pretty hard core! i actually tried to pull the visor out because it's a little crooked, not happening. you can't tell from the outside, but being a graphic designer, it bugs me. i glued one part at the top middle and the sides near the bottom, the sides of the eye slot i held in with velcro. it's not perfect, but it works. i still haven't done a clear/dull coat. i'm still unsure about it. i can just see it eating away my paint or something horrible like that.

[QUOTE="fanboy, post: 93746, member: 1455"] i ended up using a plastic bonder 2 part epoxy i found at menards. that stuff is pretty hard core! i actually tried to pull the visor out because it's a little crooked, not happening. you can't tell from the outside, but being a graphic designer, it bugs me. i glued one part at the top middle and the sides near the bottom, the sides of the eye slot i held in with velcro. it's not perfect, but it works. i still haven't done a clear/dull coat. i'm still unsure about it. i can just see it eating away my paint or something horrible like that. [/QUOTE]

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification