Reply to thread

Han's the key to the pins and locking clutch backs is, the backs lock with a set screws so they will not come off unless you take them off.

I bought mine at Amazon here :   https://www.amazon.com/dp/B00J5DT4LO/_encoding=UTF8?coliid=I20LYRFH1OQEAY&colid=GZ39KQ2V0Z0O&psc=0


The pins that I use are Tie Tack bases. The tie tack bases (largest I've found) have a larger surface to epoxy down to your armor than a jewelry pin base would.

The pins that I use are also at Amazon here :  https://www.amazon.com/eBoot-Tacks-Blank-Clutch-Silver/dp/B01GFLNJQ4/ref=pd_sbs_201_1?_encoding=UTF8&pd_rd_i=B01GFLNJQ4&pd_rd_r=N79GKNB5RVEZJR0DRZ1V&pd_rd_w=8TpsP&pd_rd_wg=heknd&psc=1&refRID=N79GKNB5RVEZJR0DRZ1V

I hope this helps....


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top