Reply to thread

Message

I'm planning to use magnets to attach my chest armor as well. Question for anyone who's used washers inside the vest, rather than magnets, to keep cost down: what pull strength have you used in order to keep things secure? I'd like to use this method if it's cost effective, but I don't want to order magnets that will be too weak.

Also, has anyone successfully used magnets to hold the collar/back armor to the vest? I'd hate to have the convenience of the magnets, and avoid making any holes in the vest, just to have to do it for the collar/back anyway. Any pointers would be appreciated.

[QUOTE="JosephWesthouse, post: 367320, member: 8489"] I'm planning to use magnets to attach my chest armor as well. Question for anyone who's used washers inside the vest, rather than magnets, to keep cost down: what pull strength have you used in order to keep things secure? I'd like to use this method if it's cost effective, but I don't want to order magnets that will be too weak. Also, has anyone successfully used magnets to hold the collar/back armor to the vest? I'd hate to have the convenience of the magnets, and avoid making any holes in the vest, just to have to do it for the collar/back anyway. Any pointers would be appreciated. [/QUOTE]

This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification