Reply to thread

fiberglass RESIN the stuff that hardens fiberglass... if you have thin styrene, it will melt and warp the plastic. Though in areas of thick styrene you should be fine. For safety, just use casting resin over fiberglass to stregnthen.


But really, if you've never used this stuff, then make sure you find someone to help you !


gm


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top