Reply to thread

Message

Ok, got the back on so I needed the keyholes. Up to now I've been printing out WOF's templates, cutting them out and transferring them to cardboard by pen. This was to sloppy a method for the fine details of the keyholes so I just measured them with a good ruler and laid out the dimensions directly on the cardboard.

The results:
[ATTACH=full]82554[/ATTACH]

I alsto picked up some needle files do I can keep the details crisp.
[ATTACH=full]82555[/ATTACH]

I still have to do some more dome smoothing but this upper ear part would only be harder to do later if I didn't rough in the shape.

BTW is there a mod who can change the title to say "Scratchbuild: Carbon Fiberglass composite"?

[QUOTE="Warlord, post: 108258, member: 1737"] Ok, got the back on so I needed the keyholes. Up to now I've been printing out WOF's templates, cutting them out and transferring them to cardboard by pen. This was to sloppy a method for the fine details of the keyholes so I just measured them with a good ruler and laid out the dimensions directly on the cardboard. The results: [ATTACH=full]82554[/ATTACH] I alsto picked up some needle files do I can keep the details crisp. [ATTACH=full]82555[/ATTACH] I still have to do some more dome smoothing but this upper ear part would only be harder to do later if I didn't rough in the shape. BTW is there a mod who can change the title to say "Scratchbuild: Carbon Fiberglass composite"? [/QUOTE]

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification