Reply to thread

Thanks for the feedback.  I can certainly put the jumpers on the top next to the batteries.  I figured that may give you a bit of more working room on the bottom part - but I wasnt sure.  You can also snip the jumpers down some if need be.  They are pretty long now and can be shorter.  I was going to put the tilt switch up top but then the batteries get in the way.  So I will have to think about how to mod that.


I will also make the note about shortening the red LED legs.  Should they be just a tad above the batteries?


Thanks again for bearing with me.


Jim


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top