Reply to thread

Sounds like you're at the exact same stage I'm at with my BM RF.  The lid is still about 1/16th inch away from closing completely, I had to bend the LED pins, and the tilt switch, and I had to dremel the tops of the battery connectors.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top