Reply to thread

Message

Jim,that is freaking awesome!!! As far as measurements go the hollow rangefinders that I and I'm sure many others have is from "bobamaker" since he was the only one that recently offered them....and I just measured the interior as it came,with a width clearance of 1". If the right angle sequencing pins made up the 1/8" difference then I'd really like it if they were upright since there is still room with that respect.

Again,it's coming along rediculously AWESOME!! :cheers Thanks so much for picking up the ball and running with it on this for us.

I can't wait to see the final product with battery and a tilt switch :love

Steve

[QUOTE="DL44 Blaster, post: 44036, member: 57"] Jim,that is freaking awesome!!! As far as measurements go the hollow rangefinders that I and I'm sure many others have is from "bobamaker" since he was the only one that recently offered them....and I just measured the interior as it came,with a width clearance of 1". If the right angle sequencing pins made up the 1/8" difference then I'd really like it if they were upright since there is still room with that respect. Again,it's coming along rediculously AWESOME!! :cheers Thanks so much for picking up the ball and running with it on this for us. I can't wait to see the final product with battery and a tilt switch :love Steve [/QUOTE]

This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification