Reply to thread

Gonna have a tough time with that seam I think. Gonna take sanding and bondo, oh and lots of patience. You can probably just superglue the broken piece back on. Then once you prime it again, you probably won't even be able to tell. Good luck


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top