Reply to thread

Thanks for the kind words. It’s always appreciated. ☺️ My helmet is a fan sculpt that I’ve been working on since I was introduced to filler and fibreglass when I joined the automotive design industry in 2004. I must thank Rafalfett and Countdookie for accurate measurements and templates as well as many screen grabs. I’ve been steadily perfecting it over the years. I also acquired an ESB SE cast from minutefett last year for paint and size reference and I would say that my days of fine tuning are complete as far as I can go. I even adjusted the height of the vertical visor strip to be asymmetric like the ESB cast. I only made it as a personal project but I was approached to make some finished helmets in 2020 and it’s snowballed from there. Perfectly coinciding with RS’s aluminium ears.


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top