Reply to thread

Message

I made my butt plate out of Sintra (any thick plastic should work). I guessed at the measurements, made a template and traced it onto the plastic. Then I cut it out, sanded the edges, and used a heat gun to curve the ends.

Then prime, paint, weather, etc.

I used 2" black elastic to attach the butt plate to the codpiece with rivets. Then I simply step into it like a pair of shorts.

I hope that helps!

[QUOTE="batninja, post: 18094, member: 229"] I made my butt plate out of Sintra (any thick plastic should work). I guessed at the measurements, made a template and traced it onto the plastic. Then I cut it out, sanded the edges, and used a heat gun to curve the ends. Then prime, paint, weather, etc. I used 2" black elastic to attach the butt plate to the codpiece with rivets. Then I simply step into it like a pair of shorts. I hope that helps! [/QUOTE]

This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification