Reply to thread

Message: <blockquote data-quote="jangobobango" data-source="post: 531421" data-attributes="member: 15300">Gauntlets have been primed, wet sanded, gloss blacked, and sprayed with rust oleum bright coat metallic finish. I started assembling them too, coming along nicely. Some parts I messed up and had some runs and mistakes, repainting those. Had to do that multiple times.[ATTACH=full]237765[/ATTACH]Flamethrower box. Wooden rods hot glued in. Buttons also glued for extra support.[ATTACH=full]237766[/ATTACH][ATTACH=full]237767[/ATTACH]Repainting the interior of the helmet, since a ton of rub n buff smudged off on the inside. I first tried to prime it again without sanding but the coat got all wrinkled. So I used paint thinner and sanded then primed again, all good now.[ATTACH=full]237769[/ATTACH][ATTACH=full]237768[/ATTACH]Primed and wet sanded the chest armor.[ATTACH=full]237764[/ATTACH]</blockquote>

This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification