Reply to thread

Hi there, new to the community and enjoying what i see. I began this as a bit of an experiment as i was going to use large plastic paint buckets for some armour pieces... shoulders, possibly knees, crotch plate etc.

Foam, bondo,

plastic buckets

Suitable sized salad bowl

Heres where im up to so far and even though it will not be strictly a boba helmet, it will be heavily based on it, i wasnt sure where else to post it.

Still more to do and i may refine the visor to be a bit thinner.


[ATTACH=full]165301[/ATTACH]


[ATTACH=full]165302[/ATTACH]


[ATTACH=full]165303[/ATTACH]


[ATTACH=full]165304[/ATTACH]


[ATTACH=full]165305[/ATTACH]


[ATTACH=full]165306[/ATTACH]


[ATTACH=full]165307[/ATTACH]


[ATTACH=full]165308[/ATTACH]


[ATTACH=full]165309[/ATTACH]


[ATTACH=full]165310[/ATTACH]


[ATTACH=full]165311[/ATTACH]


[ATTACH=full]165312[/ATTACH]


[ATTACH=full]165313[/ATTACH]


[ATTACH=full]165314[/ATTACH]


[ATTACH=full]165315[/ATTACH]


This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top