Buckets and bowls build boba fett

Craftsmith

New Hunter
Hi there, new to the community and enjoying what i see. I began this as a bit of an experiment as i was going to use large plastic paint buckets for some armour pieces... shoulders, possibly knees, crotch plate etc.
Foam, bondo,
plastic buckets
Suitable sized salad bowl
Heres where im up to so far and even though it will not be strictly a boba helmet, it will be heavily based on it, i wasnt sure where else to post it.
Still more to do and i may refine the visor to be a bit thinner.

20180618_223835.jpg


20180618_231528.jpg


20180618_231839.jpg


20180618_231846.jpg


20180619_000511.jpg


20180620_172242.jpg


20180620_173416.jpg


20180619_001630.jpg


20180619_001611.jpg


20180620_213549.jpg


20180623_181525.jpg


20180623_184504.jpg


20180623_184515.jpg


20180623_185734.jpg


20180623_185745.jpg
 
Love the improv with the bowl mate! Might just want to check the thickness of the visor opening on the top section of the ‘T’. Seems a little wide, but may just be the pics.

Keep up the great work champ!
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top