Reply to thread

Message

[ATTACH=full]239326[/ATTACH]

Short little clip of the suit. There's still a few things I need to touch up on, such as the cord connection to the right gauntlet. As you can see, it fell out. I plan to use a magnet set up to keep it in place. Additionally, I do hope the weather the flak vest soon and E6000 the screws on the toe spikes going into the material of the boots to insure they don't go anywhere. Also weathering wise, I need to mist the grey onto the right gauntlet, & mist the right hose towards the base.

Above, you may notice my neck seal is loosely fitted on -- I did this to sorta elude to the look on the model, where it appears his neckseal isn't fully closed, or it's just messy.

[ATTACH=full]239327[/ATTACH]

As far as upgrade parts go, new gloves are in pipeline that will better match the look I'm trying to achieve.

<blockquote data-quote="Brokk" data-source="post: 532513" data-attributes="member: 7100">[ATTACH=full]239326[/ATTACH]Short little clip of the suit. There&#039;s still a few things I need to touch up on, such as the cord connection to the right gauntlet. As you can see, it fell out. I plan to use a magnet set up to keep it in place. Additionally, I do hope the weather the flak vest soon and E6000 the screws on the toe spikes going into the material of the boots to insure they don&#039;t go anywhere. Also weathering wise, I need to mist the grey onto the right gauntlet, &amp; mist the right hose towards the base.Above, you may notice my neck seal is loosely fitted on -- I did this to sorta elude to the look on the model, where it appears his neckseal isn&#039;t fully closed, or it&#039;s just messy.[ATTACH=full]239327[/ATTACH]As far as upgrade parts go, new gloves are in pipeline that will better match the look I&#039;m trying to achieve.</blockquote>

[QUOTE="Brokk, post: 532513, member: 7100"] [ATTACH type="full"]239326[/ATTACH] Short little clip of the suit. There's still a few things I need to touch up on, such as the cord connection to the right gauntlet. As you can see, it fell out. I plan to use a magnet set up to keep it in place. Additionally, I do hope the weather the flak vest soon and E6000 the screws on the toe spikes going into the material of the boots to insure they don't go anywhere. Also weathering wise, I need to mist the grey onto the right gauntlet, & mist the right hose towards the base. Above, you may notice my neck seal is loosely fitted on -- I did this to sorta elude to the look on the model, where it appears his neckseal isn't fully closed, or it's just messy. [ATTACH type="full" alt="1698283511585.png"]239327[/ATTACH] As far as upgrade parts go, new gloves are in pipeline that will better match the look I'm trying to achieve. [/QUOTE]

This thread is more than 7 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification