General Brax Lel's Pepakura ROTJ Boba Fett WIP

[Brax Lel]

[Pepakura aficionados get in here]. I dont think I should work on this backplate anymore, I think its too big and that I need to start a new one. My question is what can I do about it? Do I start a new print and scale it to fit my shoulders? How can I scale? Do I need some sort of key to save my work after I scale? If so, does anyone have a key available so I can save and view my scaled backplate in Pepakura Designer? Is the orange or purple arrow width or depth?

 

[Brax Lel]

Reserved for more

 

[Brax Lel]

What feels like almost an entire year back from the dead with new content!

Below is what I have so far done in Pepakura and yes that's a Mk6 Mjolnir helmet in the back. Up next, body filler!

 

[Brax Lel]

Could someone here post pictures of the back of ROTJ Boba Fett's helmet? I'm confused by how different the Casio MQ-1 looks than the keyslots look on the CRL. Also, are the ESB and ROTJ the same cast?



https://www.facebook.com/groups/100...1554060874689965&notif_t=group_post_approved#

 

[Brax Lel]

How should I put in turn signals? I was thinking either layers of non corrugated cardboard or cutting the turn signals out completely and add a backing. What tools should I use for doing the turn signals?

 

[Brax Lel]

Is twill the right material for fightsuit and vest? Which number is accurate for vest and flightsuit? Are flightsuits and vests 2 different color of fabric? Would cotton twill be 501st approved or does it have to be tackle twill? If so where or how can I get or make tackle twill?

 

[Brax Lel]

Boba fett cod

Has any one got the pepukara files for boba fetts cod I've got the rest just need this Thanks

www.thedentedhelmet.com

Is tbone9600's Pepakura file 501st approved? If not, where can I find one that is?

 

[Brax Lel]

Should I start over and make one that is less warped or can this be saved? How can I solidify the center missile and have it threaded into the jetpack?

 

[JSmails]

I sent you a PM but got no reply. Can you send me the jet pack pepakura file you used? Or show me where to get it? Thanks.

 

[Brax Lel]

I sent you a PM but got no reply. Can you send me the jet pack pepakura file you used? Or show me where to get it? Thanks.

Dont remember where I downloaded it but here it is A4 Soba. Im planning on redoing my jetpack with FettJet file.

 

[Brax Lel]

Hey everyone, how do I know if my chest plates are too big?

 

[Brax Lel]

I held the plates on via tape for the picture. Are my chest plates too big? Should I start over?