Reply to thread

First off, hello everybody!


I'm having trouble with my braided hoses.  They're too rigid and every time I move py arm, they break off the bottom gauntlet hose connector.  Has this happened to anyone else and is there a way to soften the hose so they bend easier?


Oh, and the first person to perversly chime in about the "rigidity of my hose" recieves a lump! :-)


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top